Using built-in shapes in Keyer

There are a set of preset shapes built into the mask section of the keyer:

To access these shapes, first enter the keyer and select key, mask, setup, load setup (different locations in 4.7 and 5.0 – see illustration)

load menu for 4.7
in 5.0 it is just to the right of setup

 

Once in the load menu switch from “custom”:

 

 

 

 

to “default”:

 

 

You will see the shapes shown at the start of this tip. Once you load the shape you can use the axis above the geometry to scale or move the mask as a solid shape as needed.

 

Submitter: Jeff Heusser